September 20, 2006
1) Sometimes you may get a message stating that “many errors occurred during processing” and the Error Log notes something like “Hinge Point … not on surface”. If this was very unexpected, the first thing to suspect is that the incorrect Original Surface was selected when the roadway modeler was run. This happens when another surface was set to active and the modeler attempted to find intercepts for the cut and fill but the slopes were beyond the DTM. Sometimes the modeler is run, and then when it’s complete, a minor change is immediately made by the user and then it is re-run without resetting the original surface. This can bring about this error message. (pg. 569)
2) The Roadway Modeler will not update the TC Lines in the plan view if empty surface is toggled on even if these TC Lines are displayed in Pencil. (pg. 570) |
