Issue 51

August 5, 2006

1)Sometimes while attempting to run the Roadway Modeler an error message like “Horizontal or vertical control alignment ‘(null)’ not found.” pops up. This message will appear when trying to run the Roadway Modeler when the Roadway Definition contains independent control that cannot be processed. Check to see that any alignments used in any independent control do in fact exist in the active Geometry Project. (pg. 569)

2) Before modeling the roadway the Interval that Cross Sections will be created should be considered so that the catch points will be properly developed at the sections displayed in the Cross Section Set. This is to ensure that the section precisely shows what was modeled and is not an interpolation of data between calculated stations. (pg. 597)