Issue 35

May 6, 2005

1) During roadway modeling, the Backbone is always defined by the Template; however, the Cut/Fill slopes can be defined by four different methods: the Template cut and fill definition, a Cut/Fill Table, a Material Table or a Decision Table. (pg. 469)

2) Layers in a Template are ordered in the sequence that they are created. InRoads V8.4 and beyond has the ability to reorder these Layers in the Edit Template command. InRoads V8.2 has some limited reordering capability using the Layer Controls tab on the Roadway Modeler command. (pg. 470)

3) Creating TC Names that incorporate a left and right prefix or suffix into them will open the door to providing better control during modeling. (pg. 474)