Issue 23

September 27, 2004


1) If you are going to model a roadway that requires a special typical section to be applied at a driveway, then you will need to add a Roadway Entry in the Roadway Definition at those locations in order to have InRoads model there.

Also, if you plan to cut cross sections at these locations, you will either have to set up Custom Cross Sections or add Event Points at those unique places. Event Points can be set up at these spots to assist with modeling, creating cross sections and stationing. (pg. 565)

2) When running the Roadway Modeler, the low and high spots on a vertical curve are not automatically modeled. If this is needed then an Event Point should be placed at these locations and then Critical Sections should have Event Points toggled on. (pg. 565)