Issue 19

July 26, 2004


1) When deleting PI’s with the Horizontal Curve Set tool Delete PI, whose source were points from the Cogo Buffer, the points stored in the alignment are deleted but the original points remain in the Cogo Buffer. (pg. 331)

2) When inputting Geometry Point Names into InRoads, the Locate button can be used to select the points, or the Point Name can be manually entered. When using the Locate button to pick points, remember that this method of selection is Snap lock sensitive. (pg. 343)

3) The Curve Definition can be changed from Circular to Parabolic by going to the Workspace Bar and right-clicking on the vertical alignment name to pop up the shortcut menu. On the shortcut menu are options to use Circular Definition or Parabolic Definition. (pg. 408)