Issue 18

July 13, 2004

1. If you want all points placed within InRoads to be named points versus unnamed points this can be defined under Tools> Options on the Geometry tab. Just set the option at the very bottom Point Names During Edits to ASSIGN. (pg. 320)

2. When laying out curves with the Define Curve command from the Horizontal Curve Set tools, a message may appear saying Solution overlaps or contains discontinuities. This means that the software can’t create a curve that will fit between the PIs on either end. (pg. 323)

3. An Element in InRoads terms refers to either a Point, Line or tangent, Arc or curve, or Spiral depending on the command in use. (pg. 331)