Issue 15

May 20, 2004

1) When an input field or tolerance setting is set to 0.00 that field is ignored. This applies to the triangulation Maximum Length, Angle Tolerance, Maximum Segment Length, Point Density Interval, and so on. ( pg. 257)

2) By default, when a new Geometry Project is created, an empty Cogo Buffer is also generated under that geometry project name. However, no alignments or other placeholders are created without additional direct user input. (pg. 288)

3) You can right-click within either the Workspace Bar or the Feedback Pane to access the data shortcuts. ( pg. 296)