Issue 11

April 14, 2004

1.When Exporting Geometry to a surface, the alignments being exported must all fall within the limits of the surface. If they do not, no part of the geometry will be exported. A message indicating “Point not on Surface” will be seen in the Status Bar. pg. 616

2. To see and work with any InRoads data in the Workspace Bar, that project data must be first loaded into the software memory by going to InRoads> File> Open. pg. 18

3. If a horizontal alignment is edited after the vertical alignment had been created, it’s important to assess the impacts on the vertical design prior to implementing the change. pg. 26